The most recent content from our members.
Hello, Our team needs a dashboard that shows active alerts, and each dedicated raw for the alerts should be remove when the status is cleared or the trigger condition is no longer true alerts Like Node Down and High CPU Load ... the issue I have faced as this is not applied to all kind of alerts I can see some alerts have…
A number of years ago in an Enterprise Operations world, there were random occurring interface errors. An alert was cultivated to capture and help watch these events and trend interface errors to determine where fiber, sfp's and their connections connections may need to be cleaned and or replaced. So when I heard the…
I have a bunch of Custom SQL Alerts set up. Most of them are not having any issues, but i am having an issue with custom pollers. I noticed that we haven't had any alerts going off so i went into the alert and copied the query and ran it in MSSQL and the query returned results. I did some troubleshooting then i opened a…
I am trying to setup SQL Job Threshold Alert. We have a job in SQL that get stuck in loop we need to get notified if it running longer then normal. Attached is my setup for the alert Added SQL Server and SQL Job to monitor. Next step I am no 100% sure we exactly you set the threshold alert. I used the condition must exist…
Hi, We have created an alert based on Custom SQL. This alert check the nodes that do not have responded to SNMP or WMI query over 60 minutes. So the alert's trigger condition itself is: SELECT nodes.nodeis as netobjectid, Nodes.caption as name from nodes where status = '1' and objectsubtype in ('SNMP', 'WMI') and…
This is from a related discussion here. I want to send out Alerts when a particular node stops responding to SNMP polls for whatever reason. Obviously this needs to exclude Nodes managed by Non-SNMP means. I found CPULoad_Detail table gets updated once every polling cycle for each node. Is it possible to alert if it has…
I have my CISCO EMs and would like to create a custom alert that would trigger once the temperature of any device increase by say 4 degrees within 24 hours. How would I configure this?
So I am fairly new to Solar Winds and I've been asked to update a "Node Status down" alert to include information for a remote database with contact info, etc for the site. Currently the email is this: ALERT: ${NetObjectName} is ${Status} at ${AlertTriggerTime} ${NetObjectName} has been down for more than 15 minutes.…
Hello, After getting nowhere with support who are refusing to assist with this I was hoping some other users of NPM may be able to assist since "SQL Querys are outside of support scope", even though I dont agree the SQL is at fault. Basically I am trying to alert for certain IP Addresses where 4 of my 5 custom properties…
It looks like you're new here. Sign in or register to get started.