The most recent content from our members.
Be able to assign the Virtual Routing and Forwarding poller for Arista EOS devices to allow you to monitor the following in the VRFs on a device: * BGP Neighbors * Interface IP addresses * ARP Entries * Routing Table
I am trying to configure alerts for Routing Neighbors (OSPF and BGP). I have used the logic below to build out the alerts. I am seeing the interfaces going down with the out-of-the-box alerts but I seem to be missing the trigger for the routing neighbors. This is currently alerting on Routing Neighbors. Any help would be…
HI all, Running NPM: 2024.2.0. Trying to monitor BGP status with NPM, and realised that on the FTD the routing option is limited to Routing table only whereas Cisco ISR4k router have BGP neighbour. Am I correct in thinking that it is not possible to monitor BGP status of Cisco Firewall, Firepower2k running FTD v7.2.7 to be…
Hello all. Still pretty new to this Orion alerting however, running into an issue with BGP neighbors alerting after they shut down the interface. I'm assuming this is because the config for the BGP neighbor is left in an idle state and the interface was only shut down. If the config for the BGP neighbor was removed from…
Hello - has anyone tried setting up a custom SWQL alert for a flapping BGP route? I've tried as follows and stuck at an invalid query. Happy to hear alternatives of setting up this alert. We're on 2020.2.5 with legacy syslog viewer. Below SWQL query returns the total flaps. Not sure how I can translate this into a…
We need to add the Routing Neighbors monitor to our FatPipe devices that are monitored by SolarWinds. Under Node Details > Manage Devices > List Devices for the FatPipe the option ‘BGP Neighbors’ is not listed. All the available options are currently selected. How can we monitor BGP information for this node? Is FatPipe…
I have a PE <> CE Scenario, i monitor BGP on the PE and it works fine. What i am trying to achieve is: - if CE is down, dont trigger the BGP alerting on the PE Any given CE could have multiple BGP neighbours, for different VRF's. And if the CE goes down, we can react to the node down, there is no need to have the…
I created an alert for BGP. However,I could not get the variable that would show the neighbor desciption. Is this possible with NPM 12.5?
I'm looking to monitor a few palo alto devices for the status of the BGP routing. I've been working to configure the UDP with MIB 1.3.6.1.4.1.25461.2.1.3.2.0 (which looks to contain what I need according to the palo KB), but each time I attempt to test it - I get a message saying "The OID is not supported." I'm very new to…
Hello, This is a pretty "beginner" level question, I am just struggling to understand the full picture and am hoping someone can explain things in simpler terms. My goal is to attempt to replicate ThousandEyes's BGP monitoring, SPECIFICALLY it's "Path Changes" alerts. 1. I don't fully understand what this is using to…
It looks like you're new here. Sign in or register to get started.