Get the latest news about SolarWinds Network Configuration Manager (NCM)
I am new to SolarWinds and we are in the process of setting up SolarWinds for the first time. All of my network gear uses a device prefix based on the site. What I am looking to do is set up a lookup table with the device prefix, official site name and the support engineer. I want to be able to use this when I run my…
Hi Fellows, When we are fetching backup or compare configurations from fortigate predifened template ,it always shows user name as (TACACS) , we need the actual login user name like (salman.) Who is performing the change... Please guide the solution
I'm wondering if anyone is aware if NCM can backup Cisco MDS SAN Switches or Cisco's UCS 6120 Fabric Interconnects. Thanks! Jeremy
I am trying to define what data is being stored in the ID Column of the NCM_Audit Thanks in advanced
Just looking to garner some input from the sub in regards to network configuration management platforms. We're going to be migrating to Cisco Nexus switchgear for everything that isn't user access layer. Currently have HP 3COM stuff that is being phased out. I'm mostly familiar with the Solarwinds Orion NCM, and it's…
We have several Juniper 4200s and 8200s monitored by NPM and setup for NCM backups. These devices always show up on the Overall Running vs. Startup Config Conflicts. I am not sure what NCM is comparing since Juniper OS only has a running configuration so there is not a startup config to compare against. Is this why they…
Hi Team, Can you share a firmware upgrade template for Cisco ISR 4221 router as i will be needing this for my client. Hope you could help me address this requirement thank you!
Hi, Can anyone tell me where can I find a document telling me what ciphers and algorithms are compatible with NCM. We have Palo Alto gear that we strength security on and it basically dropped off of our NCM. Support has not been able to give us firm answers which makes it a task in itself trying to tell our network guys…
I'm struggling to understand how exactly I should configure the XML-file for an unattended install and configuration of NCM. This is the article I have been reading:…
So I have created a job that then sends the output to a file on the server, I want to have the host-name of the device that I am running the job on so that it is obvious which device this is for. I don't want to hard-code the host-name of the device so that I can run the job on lots of devices and it will save a new file…
It looks like you're new here. Sign in or register to get started.