The most recent content from our members.
So I have an alert create when a subnet reaches 90%. The only thing is when I run IP Address Tracker the subnet is is only at 75% I have the transient set for 1 day so it can be as accurate as possible. Trigger:
i need to configure an alert for a flapping tunnel Note: Flapping doesn't mean the tunnel interface is down, the flap might result in high latency or high response time during ping this basically means the connection/communication between the two ends isn't stable. i will appreciate any hints, link or resource that will be…
Hi, Greetings! I am collecting alerts messages from AlertHistory table joining with AlertObjects and Alertconfigurations using SWQL/API. Here I am getting all the alerts with severity Warning (1), Critical(2) and Serious(3). And also with severity information (0). But there is no alert message specified as this information…
Has anyone had issues with alerts not clearing due to a node (or perhaps the same for interface?) going into an unmanaged state after it has already triggered alerts? To clarify a bit with a specific example- * I have a node that triggered 3 different alerts. The node was then changed into an unmanaged state and therefore…
Hi, I have created a new alert to alert when a datastore goes below 201GB, the issue that I have however is how to get the node name in the email alert, Together with some Custom Fields found on each node. I have been scratching my head on this one, and I am not sure if I should be resorting to SWQL or SQL to get this done?
NPM 12.4 Does anyone have a condition on where NPM will alert when a 3850 single or stack will alert when the system is running a high temperature? Speaking with SW-Tech we could only create per sensor rather than Node alone. So this would give me an alert per sensor. IE: 1 switch would send 2 emails with high degrees
Hey guys, I am not sure that I can do what I want to do. I am trying to add a link to the Alert Details page. That changes with the alert. I can of course add a link to the alert message but on the Alert Details page the alert becomes un-clickable. So I tried other options such as a custom property, or adding it to the…
I'm trying to use these attributes but only one is populating ${N=SwisEntity;M=DetailsUrl} - This one populates ${N=Alerting;M=AlertDetailsUrl} - This one shows up with nothing ${N=Alerting;M=AcknowledgeUrl} - same as this one -----Here's a screenshot----- -----Version details-----
It looks like you're new here. Sign in or register to get started.