The most recent content from our members.
We had an incident this morning where one of our 6509 VSS Chassis failed but no alerts were triggered as the other chassis was still up and active and didn't realise the chassis was down for 2 - 3 minutes. I can create an alert based on if the supervisor is up or not but what I really want is a generic alert for any…
So I keep getting these messages from NTA: NetFlow Receiver Service [MainOrionServer] is receiving Netflow NetFlow data from unmonitored interface Vlan432 on CoreRouterSwitch. Click Monitor NetFlow source or enable the "Automatic addition of NetFlow sources" option on the NetFlow Settings page to process future NetFlow…
I have one of my Cisco 6509 shows high response time ( above 200 ms & range between 200 To 1800 ms) which is very high for the LAN environment. When I ping the same ip that I have in solar winds, I do not see this high response time. I am trying to figure out what Solar winds use to determine this value. Also I would like…
I have configured my 6509 switch for netflow to look at the traffic on a gig interface. The configuration is below. My question is that although the flow-export version is 9. i cannot select 9 for mls nde sender version. The options are 5 or 7. What is the defference for mls nde sender version for 5 or 7 and will it have a…
Here's what my log file looks like on one of my core 6509s (imagine about a billion more though): Jan 25 15:06:19: %SNMP-3-AUTHFAIL: Authentication failure for SNMP req from host 10.16.2.142 Jan 25 15:23:42: %SNMP-3-AUTHFAIL: Authentication failure for SNMP req from host 10.16.2.142 Jan 25 15:35:39: %SNMP-3-AUTHFAIL:…
I'm trying to configure my Visco 6509 sw using the Netflow configurator but I'm getting the following error message: "The device you specified does not allow the configuring of Netflow support ... through snmp." When I looked up the minimum specs, the documentation reported: * The following Cisco IOS versions support the…
Hi, I have 2 identical Cisco Catalyst 6509 devices, running on 12.2(18)SXD7b and with PFC. However, NTA failed to detect one of the devices. I checked on the device configuration and it is correct. Any possible solution for this? Thanks!
Hi, I have a problem while enabling Netflow on Cisco WS-C6509 running on IOS 12.2(18)SXD7b, hopefully someone can help me on this. I can't seem to be able to use ">#ip route-cache flow" command in the interface configuration mode, says the command is invalid. I also tried ">#ip flow ingress" and ">#ip flow egress", also…
Hi, I tried to enable NetFlow on the interface for Cisco equipment running on these IOSs and seems like >#ip flow <ingress/egress> doesn't work. But according to this document (http://www.solarwinds.com/support/Netflow/docs/OrionNetFlowSwitches.pdf), it should work. Any way to resolve this? Thanks. Actually I am also not…
Hi, is the CLI code shown below applicable to all these Cisco products? (7606-S, 7606, XR 12406, WS-C6506-E, WS-C6509, WS-C3560G-48TS and WS-C3560E-24TD) #ip flow-export source interface0/0 #ip flow-export version 5 #ip flow-export destination xxx.xxx.xxx.xxx 2055 #interface interface0/0 <interface0/0>#ip flow egress…
It looks like you're new here. Sign in or register to get started.