The most recent content from our members.
Hello, In a recent case, we noticed that CatTools still uses bigpipe commands to back up Big-IP, except that this command is no longer supported since version 11: the new standard is the tmsh command. For your information, our Big-IPs are in version 17.
Greetings - Is there some way to use just an F5 Virtual server or iApp on a Solarwinds Intelligent map or dashboard? From what we figured out we were only allowed to put the entire F5 on the map. Thanks! Dave
Hi All. We already added our F5 device and it is already being monitored. However, on Load Balancing page, it says that there's no any F5 load balancers being monitored. The F5 Big-IP on list resources is already checked and we still experience this issue.
There is either a big miss by SolarWinds when it comes to the management of the relatively new F5 Polling feature, or I'm overlooking something on my end. I've been a big advocate of the new Manage Pollers feature (AKA: Device Studio) because it has made bulk editing standard poller assignments much easier, as well as…
Multi CPU & memory poller for F5 BIG-IPs
I'm getting bad information from SolarWinds on my F5s' CPU load. They consistently stay at 97% or 99% usage in SW, when in reality they're somewhere around the 30's. Models doing this: BIG-IP 1600 BIG-IP 3900 BIG-IP 4000 I'm aware I can just poll more specific OID's and alert on those instead, but whenever someone browses…
My knowledge of F5's is practically null, so I'm hoping people smarter than I am about this subject can help me out here. We have a F5 Viprion Chassis to monitor with 3 blades in it. Those 3 blades have 5 Virtual devices spread across them. What we're trying to do is find a way to properly monitor the chassis itself. We…
I constantly get high cpu usage from our GTM devices but in reality usage is very low/minimal. I have done some research and there is a way to calculate accurate usage but it involves multiple SNMP queries to get initial values and then to calculate based off of delta...I do not think this is possible via Orion today. How…
I'm running NPM 10.7 and there still doesn't seem to be anything that would alert based on pool member status. Does anyone have some custom tricks I could try out? Thanks!
Hi I am trying to create some custom pollers for CPU usage and Throughput for F5 BIGIP and running into some problems. Looking at the docs provided by F5 Here is how they suggest reporting on CPU Usage.. The question, I have is how do you create two separate polls at 10 seconds apart 1. Perform two separate polls of total…
It looks like you're new here. Sign in or register to get started.