The most recent content from our members.
I have found that there is a limit of nine trigger conditions in one statement. After that, the SWQL statement shows repeated values instead of new entries. Is this a bug or a limitation in the software?
I'm trying to figure out if this is even possible: I have a Custom Poller monitoring the disk drive status in a Dell Server (using OID 1.3.6.1.4.1.674.10893.1.20.130.4.1.4). The Custom Poller is returning the data in an enumerated table, one row for each disk in the server. I have an Advanced Alert setup to monitor that…
lI've had multiple areas I would like to alert on (VIM_Hosts and several others). Unfortunately I've not found a way to do this beyond trying to hit another location (like SNMP). This doesn't always allow me to catch what I'm looking for until after the event. An example I would like to do is - SELECT HostName,…
Hello, we have some administrators who are stopping snmp, changing snmp community etc, without notification which is resulting on NPM not able to retrieve the data. Appreciate if there is a way to monitor this by Advanced Alert Manager , being on HP-UX, Solaris, Linux, etc.
Hi all, I have multiple UnDPs which all contain "currentSLMresponse" which are assigned to a single node. I want an email alert if the rate on any one of those UnDPs is zero for more than 2 minutes however the below will not work. Assume i poll every minute, at minute 1, lets say currentSLMresponseServer1 has a rate of 0…
I am in the process of building my first alert, and I was hoping for feedback to make sure I am doing this the right way. We have several nodes that we only want to alert us if they go down during specific hours. I figured the way to configure this alert is the following: Do I have the general form down correctly?
I have an Alert that triggers if a Group status is down: TriggerAlert when ALL of the following apply Group Name contains Network Group Status is equal to Warning Whic works fine unless a staus of another member in the group goes down in which case I would like to get a message again. So I tried to update my trigger to…
It looks like you're new here. Sign in or register to get started.