IP SLA Latency value red

Hello!

I have recently installed the latest version of IP SLA Manager. For some reason, all latency values above 100 ms displays with red numbers. Since we have a very distributed network, our normal latency values ranges from 5 ms to above 700 ms, so 100 ms is not a critical value for me. Is there any way to adjust this threshold individually for each node?

I have tried different values within the Edit Operation properties, but the latency value is still red even when within my threshold value.

Thanks,

Erlend

Find more posts tagged with

ip_sla

ip_sla_manager

ip_sla_alerts

Accepted answers

All comments

macnugetz

Hi erlend,

Sorry for the delay in responding; we were trying to reproduce your issue, and were unsuccessful in doing so. I'm assuming you're referring to the gauge values, which you should be able to edit the thresholds accordingly. I just tried it and it worked for me.

At this point I would recommend opening a support ticket and reference this thwack post.

HTH,

Craig

derhally

what is being reported for "Status" when you look at the Operation details resource for that operation?

erlend.smordal

Hi, and thanks for your replies.

Operation Status says "Warning". Status Message is "Warning threshold level reached for: Round Trip Time".

The actual latency for this path displays in IP SLA as 700 ms, and the latency threshold value I have defined in "Edit Operation" is more than the double; 1700 ms.

I suspect that IP SLA references to a global value in NPM Settings; "Response time" Warning level. But even when setting this value to 1700 ms it is not reflected in IP SLA. The warning is still active, and the latency value displays as red for some reason.

I might do as suggested and open a ticket on this case.

GGray

Was there a solution to this problem? I'm getting the same thing. ie. IP SLA HTTP operation continually 'warning' even though thresholds are set way above actual results.