I've created a custom report to show Node Down time which displays as start and end time and includes total outage time in minutes. I'm assuming this is built off of Event Log entries. We use this report to identify health trends of data circuits and determine if a chronic issue exists. The ability to add a historical comment to the event log entry to reference the cause of the down time (i.e.,: Carrier replaced Smart Jack, Power Outage, LEC repaired cabling.... etc, etc......) would significantly improve the usefulness of this data as it would cut down on the time required to investigate (and re-investigate) the cause of the outage every time the report is viewed.
Data Selection
Report Table Layout
Report Output
