Get the latest news about SolarWinds Network Performance Monitor (NPM)
Hi Team, I am looking for a way to bulk-select specific interfaces for monitoring across our onboarded WAN switches. Specifically, I need to monitor all interfaces that contain the string "VNI" in their description or name. We have over 200 nodes already in the system, and manual selection for each node is not feasible. I…
Is it possible to send some syslog information from SolarWinds to another platform namely Power BI (Microsoft)
Hi. need you all solarwinds expert help to guide me to solve this issue. currently now we are facing alot of alert flood in our mail. when i was checking the issue is the site is down and all nodes are detected down. we are looking for any ways to prevent alert to trigger for all the child devices which are connected to…
I am running version 2025.4.1. The issue is that I am trying to use a custom table widget to display a custom SWQL report and the data shown in the widget is not complete when compared to the report. The report shows data for an expected 52 nodes, but the table widget linked to the exact same report shows 149 total rows…
I have created undp pollers and assigned to certain nodes. I am now trying to figure out how to display that data on those select nodes on their respective page. Is there a way to display this data? I tried to do a custom widget which worked but it then added to all the nodes.
In NPM would like to create alerts that can trigger email with the results of the hardware sensor status plus IP address of the node device. Usinging alert management there is a built in alert "Alert me when any hardware component goes into a warning or critical state". This will alert the hardware sensors however I am not…
1)We are trying to automate and create a silent configuration wizard using these steps: https://documentation.solarwinds.com/en/success_center/orionplatform/content/install-silent-mode.htm?cshid=orioncoresilentinstall 2)We created the silent config using this command successfully: "H:\ProgramFiles\SolarWinds\Orion"…
Hi all, We have self hosted NPM with Netflow, NPM, and NCM licence. I am trying to monitor AWS direct connect, if I go to add cloud account AWS is greyed out but MS Azure is available for some reason? Can someone advise if this is due to licensing, a limitation of our deployment or maybe config issue? Cheers
Hi, How to monitor the BFD sessions for "Cisco Catalyst 8000V Edge". We polled them via snmp
I am looking to create route flap alert in NPM. by default we can see route flap top 10 table in SolarWinds but not sure why they have not provided option to create an alert on it even though its part of threshold setting as well. Any better way to to create alert on route flap? if somebody already using it let me know. If…
It looks like you're new here. Sign in or register to get started.