Get the latest news about SolarWinds Network Configuration Manager (NCM)
I have 4 Layer 3 Switches Lets say for simplicity They are named Router1, Router 2, Router 3, Router 4. Inside the configs I am looking for those that don't have session-limit 2 in their configs. However Router1, Router2, and Router3 don't support this command so I want to exclude them from popping positive on the…
Hi iam unable to download config by NCM of Cisco ASA 5545 error: Connectivity issues, discarding configuration (or configuration is too short)
The below is a solution for backing up F5 configuration and UCS images, functional requirements : a. Backs up / tracks most / all changes on all F5 partitions. b. Backs up the F5 master key. c. Backs up the F5 UCS image file. Key points are that it backs up F5 objects to solar winds across all partitions, also backs up the…
I am unable to configure NCM to directly pull the config from a device due to security restrictions. May I push the config backup to a intermediate server and Solarwinds NCM can pull the backup from there and display backup file in NCM dashboard?.
Hi all Im new to solarwinds and was wondering if there is a way to monitor and set up an alert for when a VPN goes down. I know VPN's are torn down when there is no interesting traffic going through but i was wondering if anyone has set it up so that you get an alert if the VPN has been down for like 5 mins or so. Any help…
I have been reading exhaustively been trying to read the many manuals online and dig through forums to no avail. What I was hoping to do is build a new type of config template to use for downloading. The main reason I want to do this is to capture pieces of a CISCO device that are only available via specific commands. I…
Hi all, would it be possible to pull Aruba configs without Telnet/SSH? Thanks
I'm looking to script the config of some Cisco devices. I am happy to select the nodes and interfaces and configure them all with the same config. However I have two lines of config per interface which are dependent on the switch access vlan number. So does anyone know how I get this as a variable and config the interfaces…
I am currently running NCM 2020.2.5 (Orion 2020.2.5) and get an error when I do Compliance Policy Reports Updates for certain reports. I imported from Thwack the DISA STIGS for the following CSCO-IOS-RTR-NDM CSCO-IOS-RTR-RTR CSCO-IOS-SW-L2S CSCO-IOS-SW-NDM I imported the reports and assigned them to a folder. All is fine…
New to NCM Trying to craft a rule to help identify switch ports that do not have 802.1x configured. I can't seem to get the logic right. I am doing a 'String does not exist' and block mode regex - interface (.*) string - switchport mode access string -dot1e pae authenticator The logic should be for each interface that if…
It looks like you're new here. Sign in or register to get started.