Get the latest news about SolarWinds Network Configuration Manager (NCM)
Hi Is there way to define 5 or 6 config lines, let say for interface of switch with speed and mtu and nego , and do compare in all the switches port at the NCM And to check on which ip and port there is mising lines ?
I am using SolarWinds NCM. If I execute a script on 100 nodes, does it try to log into the nodes at the exact same time? If so, can this be adjusted so that login attempts are staggered? Using a separate update script (not Solarwinds), it appears our TACACS server is incorrectly detecting a DoS attempt and failing attempts…
All the NCM compliance report is stuck on last week, it shows the last update date of last week, There were no changes made on any rules and policy, Backups are also OK. What could be reason for the Update stuck and the cache status shows the value 3 on the DB for all the reports. Whenever am trying to view report, it…
I use NCM compliance report and remediate interface configuration. For example when I find 'switchport access vlan 2', it add config 'switchport mode access' from Remediation script. But after remediate config, I would like to save config as the below. ${ConfigBlockStartLine} switchport mode access {{ end Loop }} end wri…
For some reason, when I click on the "Execute Remediation Script on this note" from reports, the script does not run. I am in CLI mode and "execute Script in config mode" is checked. IF I also check "automatically execute script when violation is found" the script runs fine and the change is pushed out. I like to manually…
Ignore this post, I put it in the wrong location.
Where i can see the log of the smtp server ? I have problem when i create job on NCM and i enable the smtp server and i am not recive the email . When i click on test button at the NCM smtp i am recive the email test .
I have the same layout at multiple sites with multiple VLANs. I would like to script adding a DHCP scope to a subnet for a specific VLAN in each site but the subnet is different in each site. Is there a way to do this with variables to get the subnet from the switch before inputting the config for the scope.
Dear team, if we used " NCM DL200" can we schedule three specific time scheduler to upgrade the Cisco IOS firmware with 200 nodes(switches)same time on each specific schedule time. Thanks
From a PCI environment the auditors want to know of NCM can use MFA to get to the network devices. I'm feeling skeptical on this one. But any confirmation will help. thanks
It looks like you're new here. Sign in or register to get started.