Get the latest news about SolarWinds Network Configuration Manager (NCM)
The prior UI had a report or display that checked each device config against baseline and showed that result on the dashboard. i switched over to the new UI and no longer have that option nor have i been able to find a widget or config to recreate it, help? it used to show a pie chart indicating the number of configs…
Is there a better to assign a connection profile to 1000+ Nodes than going to the settings>All settings>NCM settings>Connection profiles>Assign to Nodes.?
Good Day All We do not have baselines set but now we have a requirement to notify when running and startup dont match. My initial thought was using baseline for startup and comparing the running to it, but startup configs do change so is there a way to update the baseline automatically when the startup has changed, that…
We've found that when we run the update inventory job for ncm we aren't pulling back all the information we need. Some devices respond with more information when using admin show inventory rather than just the based show inventory. Is there a way to update who NCM obtains this information to add to the inventory…
Hi Is there way to define 5 or 6 config lines, let say for interface of switch with speed and mtu and nego , and do compare in all the switches port at the NCM And to check on which ip and port there is mising lines ?
I am using SolarWinds NCM. If I execute a script on 100 nodes, does it try to log into the nodes at the exact same time? If so, can this be adjusted so that login attempts are staggered? Using a separate update script (not Solarwinds), it appears our TACACS server is incorrectly detecting a DoS attempt and failing attempts…
All the NCM compliance report is stuck on last week, it shows the last update date of last week, There were no changes made on any rules and policy, Backups are also OK. What could be reason for the Update stuck and the cache status shows the value 3 on the DB for all the reports. Whenever am trying to view report, it…
I use NCM compliance report and remediate interface configuration. For example when I find 'switchport access vlan 2', it add config 'switchport mode access' from Remediation script. But after remediate config, I would like to save config as the below. ${ConfigBlockStartLine} switchport mode access {{ end Loop }} end wri…
For some reason, when I click on the "Execute Remediation Script on this note" from reports, the script does not run. I am in CLI mode and "execute Script in config mode" is checked. IF I also check "automatically execute script when violation is found" the script runs fine and the change is pushed out. I like to manually…
Ignore this post, I put it in the wrong location.
It looks like you're new here. Sign in or register to get started.