Get the latest news about SolarWinds Kiwi CatTools
Hi, since we upgraded to FortiOS 5.2.5 or 5.4 Cattools gives us the error message "Failed to connect to XXX. Reason: No respone from remote host. Will try again." If we connect to it with Putty we get a session. Have debugged the SSH from FortiOS but no error messages is shown. The debug in Cattools doesn´t give any errors…
Hello Dear! I have configured in some UPS Nobreaks the Syslog Configuration . I have the feature Kiwi Syslog Server for monitoring. But when the nobreak sends Week tests, the following error are displayed: 05/25/2015 22:58:48 UPS: Restored the local network management interface-to-UPS communication. 05/25/2015 22:58:33…
We have 2 riverbed devices and we setup Kiwi Catools to backup the config. Unfortunately the backup failed each time and the error message is: Enable mode failed. I've put the correct passwor to login to the Riverbed but we didn't setup password for enable privilege. Thank you for your help.
Good morning, I am using Kiwi CatTools to save the Cisco switches config. I am now facing the situation where I have so many versions of the same config and it quickly starts to take some space. Do one of you know who I can limit the amount of configs backup before a rollover. Let says I would like to have 4 versions…
Hi Team, For specific devices i am getting error "Specified username is invalid for device" eventhough username & password is correct. i have opened putty and tested credentilas and no issue observed. attached device config & debug logs. Regards, Karthik V 0821 - 6649363
Hi all, As above really, in some scenarios we're being asked to have the configuration of particular nodes e-mailed into our monitored inbox (securely) and then stored. Can Cattools perform this? The SolarWinds CatTools manual seems to suggest it can with this line ' be aware that the HTML reports contain your full device…
Dear Kiwi CatTools technical support team, I found Kiwi CatTools 3.11 Release Candidate on SW Customer Portal Site. (https://customerportal.solarwinds.com/Home) Could you provide the contents of KCT 3.11 RC version? Best Regards,
Hello guys i hope this is the right place for it im very new to programming KiwiCat 3 It would bi very nice when i can have your help, because i can't find an answer in the Internet. I have an Activitie in KiwiCat (cattools3.10.0) that makes possible, to show me a Version Report on a Cisco Switch. I have also one for the…
how can we backup the fortimail device running devices using the kiwi cat tools , as when I use it is gives me a successful login attempt but unfortunally the tftp back gives it failed . any ideas ???? thanks all
Hi there, I'd like an example of a Kiwi cattools activity script to make a UCS backup of a F5 device. Best, Erik
It looks like you're new here. Sign in or register to get started.
