UDT not showing connected devices

Instead of looking for the port in UDT, have you tried looking for the MAC Address instead?

In Device inventory in UDT yes, it appears to be only showing wireless devices which will be from our Meraki platform but not wired devices.

can you show me a screenshot similar to the link?  I do not see the UDT Monitor Filter from your screenshot.

No problem, is it the following?

UDT monitored Nodes

UDT Monitored Interfaces

Ok, that means it should get the information.  This will now fall under support to verify if data is coming in properly.  It would be helpful if you can run UDT compatibility checker for the device/Node.

solarwindscore.my.site.com/.../UDT-Compatibility-Checker

Thanks for that, I assume this may have something to do with it?

That usually means you are using SNMPv3 for that node.  You will need to reconfigure the SNMPv3.



support.solarwinds.com/.../Layer-2-Layer-3-data-not-visible-when-using-SNMPv3

support.solarwinds.com/.../Authorization_Error_-_User_does_not_have_rights_to_requested_MIBs

support.solarwinds.com/.../Enable_SNMPv3_access_for_layer_2//3_Bridge_MIBs_for_Cisco_IOS

support.solarwinds.com/.../Layer_2_//_Layer_3_data_not_visible_when_using_SNMPv3

support.solarwinds.com/.../Missing_IP_addresses_-_ARP_contained_in_VRF

support.solarwinds.com/.../Error:_<SNMP-3-AUTHFAIL:_Authentication_Failure_for_SNMP>

Great thanks, I've configured a switch with the following and I'm now not getting that error on the UDT compatibility checker so hopefully device tracker should start to populate.

snmp-server view <OURGROUP> internet included
snmp-server view <OURGROUP> system included
snmp-server view <OURGROUP> interfaces included
snmp-server view <OURGROUP> chassis included
snmp-server view <OURGROUP> mib-2 included
snmp-server group <OURGROUP> v3 auth context vlan- match prefix

Well, hopefully it does.

It has worked, I've applied the config across all our switches last night and can see wired clients! thank you very much for your assistance! 

no problem

How long after config was applied did you start seeing the data? I am running into this EXACT same issue, have used the new commands to modify our SNMPv3 view on a test switch and just curious how long I need to wait.

Update: It took about 30 minutes for this to start working on my system. I was just being impatient since we have been trying to figure out why our UDT data was so incomplete from site to site. I never looked at what devices were snmpv2c or snmpv3 though until today. Glad this was a relatively easy fix - now just to send it out to all the switches.

How long after config was applied did you start seeing the data? I am running into this EXACT same issue, have used the new commands to modify our SNMPv3 view on a test switch and just curious how long I need to wait.

Update: It took about 30 minutes for this to start working on my system. I was just being impatient since we have been trying to figure out why our UDT data was so incomplete from site to site. I never looked at what devices were snmpv2c or snmpv3 though until today. Glad this was a relatively easy fix - now just to send it out to all the switches.