Customizing a Custom MIB view quest

Question

by default the custom mib for NetBotz Temperature Sensor value is in .1 increments of Celcius.  Is it possible within orion to convert this to F and/or also on the graph put a indicator label on the side of the graph in indicate what the values are.

its confusing just seeing a graph where the values are up above the 210 - 250 mark.  even though if you KNOW, this means is between 21 and 25 degrees C.

jkeberle · Answer

Ok this brings up a new set of questions heheh.

If I am wanting to graph data that is the true value, example in this case the mib reports back the raw temp in F.  example the mib value reports back 72 meaning 72 degrees Farenheit

Do I:

a.) use the mib value type of RAW

b.) use the mib value type of Rate, making Unit: Farenheit, and Timeframe none

c.) either works

I know that with RAW, I cannot use RADIAL DIALS, but with RATE I can.  I have several experiments going but it takes time to see which works the best.

any intuitive help would be greatly appreciated.

Don331 · Answer

Use the tempSensorValueIntF value insead.

OID is 1.3.6.1.4.1.5528.100.4.1.1.1.9

Regards,

Don