NCM Compliance Check for Storm Control and advise if not correctly set

Question

I would like to compliance report on  my interfaces for any that do not have Storm control Set as per our SOPs

storm-control broadcast level 10.00
storm-control multicast level 10.00

Anyone got any ideas or guides i can use.

In the below Example we should get a violated on eth 1/16.as has wrong settings.

interface Ethernet1/12
description Main Link
switchport mode trunk
switchport trunk allowed vlan 2-4
storm-control broadcast level 10.00
storm-control multicast level 10.00

interface Ethernet1/16
description Backup link
switchport mode trunk
switchport trunk allowed vlan 2-4
storm-control broadcast level 5.00
storm-control multicast level 5.00

Dez · Answer

This could be as simple as just defining a rule with Alert on the rule below if:  "String is NOT found"
Then place the string value to be:

storm-control broadcast level 10.00
storm-control multicast level 10.00

You'd then place in a policy and then create a report or add the rule to an existing report etc.  It just depends on how you want to use this report.   If you want to look at a specific interface(s) you can use the advanced config block and more.