Cisco 1800 not showing CBQOS

I have 11 1861s and all are configured with the below configuration. However only 1 is showing QOS stats. I have compared the router configs a number of times but cannot figure out why only actually shows that Solarwinds actually received CBQOS.

interface Serial0/2/0:0
ip flow ingress
ip flow egress
service-policy output EGRESS_QOS

ip flow-export source Loopback0
ip flow-export version 5
ip flow-export destination 172.24.99.150 2055

show ip flow export
Flow export v5 is enabled for main cache
Export source and destination details :
VRF ID : Default
    Source(1)       10.250.250.13 (Loopback0)
    Source(2)       10.250.250.13 (Loopback0)
    Destination(1) 172.24.99.150 (2055)
    Destination(2) 172.24.99.15 (2055)
Version 5 flow records
1416396 flows exported in 151213 udp datagrams
0 flows failed due to lack of export packet
0 export packets were sent up to process level
0 export packets were dropped due to no fib
0 export packets were dropped due to adjacency issues
0 export packets were dropped due to fragmentation failures
0 export packets were dropped due to encapsulation fixup failures

Any ideas for what I should check?

Find more posts tagged with

Accepted answers

mavturner

pyro13g, have you tried this again in NTA 3.8?

Chris, sorry for the basic question, but did you confirm that NTA was set to collect CBQoS information from the device and interface? If you click Manage Sources on the NTA home page, you should see an option for CBQoS. Make sure it's checked for the devices and interefaces you want.

Mav

All comments

FormerMember

Try a rediscover from manage nodes for a router not working.

Also, if you change a QoS policy at the router, it used to break it in NTA and you had to remove and reapply the policy to the interface to be rediscovered by NTA and begin working again.

Solarwinds knows there's issues with CBQoS, just isn't fixed yet.

caustin12

Thank you for the response.

I tried rediscovering the routers but it did not work. I then tried removing the policy-map statement, readding it and then rediscovering the device. No matter what order or combination I tried the device will still not show CBQOS information.

mavturner

pyro13g, have you tried this again in NTA 3.8?

Mav

caustin12

I did not check that. I assumed it was an all or nothing setting. Thank you

FormerMember

pyro13g, have you tried this again in NTA 3.8?
Mav

Tried what again? Every time I ask I get told yes we know CBQoS has a problem we can reproduce and there is nothing official as to when it will be fixed.

FormerMember

I'm having the same issue with a new device today.