The most recent content from our members.
Ability to compare “max secure MAC address” vs “current secure MAC address” and make a report that shows these differences. If you have a switch port which is configured with max allowed 10 MAC addresses but only 8 MAC addresses are currently secured (8 in use). And the port on the switch is configured with sticky. Then…
I have noticed since we started deploying port-security on our Cisco 2960-X switches that the MACs stop showing in UDT for Cisco phones. I have been comparing configs for a couple of days before I removed port-security on one of the switches that stopped working. And what do you know, the phones show up again! Below is our…
It's mentioned and listed on a slide here: https://www.youtube.com/watch?v=SdUJ47f463w#t=974 However, I cannot find this list anywhere in the actual documentation. Can someone help?
This is probably too complex, but I would like to go into a Cisco switch, see if each interface is a switchport. If it is, then run specific config commands (VLAN, port-security, etc.). Is there a template for this already?
It looks like you're new here. Sign in or register to get started.