The most recent content from our members.
I'm using the bandwidth gauges to display realtime usage for our primary internet connection. Off of it, I can spawn a historical line graph. Is there a way to change the display from the 24 hours it displays to maybe 8 hours?
Hi all, i monitor with Bandwidth Gauges a cisco 4900 Port Channel made of 4 GigabitEthernet. in the same Gauge i put the Porte channel and the four GigabitEthernet . i noted that only 1 trasmit gauge of gigabitethernet is on 1Gbps the Portchannel one shows 2Gbps in the same time. is there any problem or is normal? can…
Hello all, I noticed something interesting today regarding the Bandwidth Gauges in the Toolset. Whenever I try to monitor bandwidth on a switch with an '@'; symbol in the community string, it fails to poll the device. Switching the string allows it to work again like normal. Problem is, we have hundreds of switches with…
I have a new force10 c300 switch and when i use bandwidth gagues the gauges are set to refresh every 3 seconds, however when they display they display the value but then go back down to zero right away. Whereas my hp's stay at the value until the new value is posted. Anyone come across this before?
I'm monitoring the ethernet interface realtime speed with Solar Engineer's Toolset, and i'm using two tools - Realtime Interface monitor and Bandwidth Gauges. The results on these two similar tools are different (the difference is up to 10x times). Updating time is the same. So why is it so ?
Hi all, I am trying to add a new gauge and as it is discovering the interfaces, it stops on "unrouted VLAN 210". I am fairly new to SW, but have a good knowledge of our Cisco 4705. It is a fully switched network and am able to monitor other VLAN's as well as some trunk links. Any ideas where to begin? Thanks...
Just installed version 9.2 on Windows 2003 Enterprise Server with Service Pack 2. When I use bandwidth gauge to monitor traffics on my Cisco 7140 router, from the command line of the router, I can see that that interfage is getting about constant 45Mbps throughput. However, from the engineering tool set, I only see 23mbps.…
I am monitoring traffic on our main Novell servers via Bandwidth Gauges. The gauges that show traffic through the NICs on our main Novell servers consistently read >1%. On the bandwidth tab under tools, I have the receive and transmit both set to 1000000000 (which translates to 1.0 Gbps. The NICs are definitely 1Gb NICs. I…
I can't find anything about this issue on Thwack - I set up two BW gauges to monitor my Internet ports traffic, one port on each of two 2950 switches. The ports are set with "load-interval 30". No matter what refresh rate I set on the gauges, they seem to bounce back and forth between the real reading and zero! This…
I'm trying to add a gauge for a Nortel 5510-24T using generic "Public" SNMP credentials. The credentials test ok, but on the discovery window it says "Discovering Interfaces/Ports... 24 of 40". Why is it trying to discover non-existent ports? The discovery never completes and unfortunately I don't have another 5510 around…
It looks like you're new here. Sign in or register to get started.