The most recent content from our members.
Is there a way for VNQM to save the config after it writes an operation to a router?
We replaced a 7206 router with an ASR1002. I deleted the operation on the branch router. When I go through setup, I recreate the Jitter operation, select my ASR as the source, and the 3800 as the target. It is setup for both directions, and it finishes. The 3800 router gets updated, but the ASR has nothing new in its…
We have 2 (soon to be 4) different provider MPLS networks that we are currently using for interoffice connectivity. We've been seeing packet loss across one of these links (I'm seeing it from one of our branch sites to one of our data centers). What I'm trying to find out is what the community thinks is the best way to see…
we have customers that we expose their map to them for monitoring (we own and manage the gear). We use IPSLA pings to go across the WAN as most of our WAN has GRE tunnels across MPLS or VPN and those interfaces will show up even if no connectivity. so, I can allow them to see their IPSLA if I include the view for their…
Hey everyone, I have a few Cisco 6509-e switches where I'm trying to measure voice traffic quality throughout. I have set up the IP SLA commands using the IP SLA Manager and I am receiving intermittent jitter spikes. I have tried to increase the input queue, as well as change the ToS number to 192 (which I know I should…
If the probe UDP Jitter is configured at CISCO 7600, in the "Network Summary Home" window the correct information will be shown. However for the certain call path, data for MOS and Jitter Latancy are not shown (No Data For Selected Time Period) For the probe configured at CISCO 2800 all the data are shown correctly. In all…
I am trying to create a TCP operation to monitor TCP round trip time to a site out on the Internet, however when I try create the operation there are only three types of paths to select, and all three paths expect the nodes to be monitored to be already in the IP SLA nodes list. This is fine for the SLA router on my site…
I am working in the VoIP Monitor section of Orion and trying to use the configuration wizard to get this set up for our voice group. I go to VoIP Settings > Settings > Manual Config and find the config instructions at the top of the page. I log into one of our routers to be set up as a call path and go into config mode. It…
It looks like you're new here. Sign in or register to get started.