The most recent content from our members.
Hey Thwack, Has anyone configured an ASA for Real Time Configuration Monitoring? I have it configured for our switches and it is working great but the commands are different on an ASA. Here is what I have so far: Cisco Adaptive Security Appliance Software Version 9.1(2) Device Manager Version 7.1(3) snmp-server group…
Hello, I have RTCCM enabled and working fine for me, using syslog viewer. Hoever, I added a few more devices and I get emails for none of them. The old devices are still sending alert emails. I checked on the Routers, they have the correct settings, and the Syslog Viewer sees the logs saying "Configured from console", and…
Hi, Has anyone configured real-time detection for Cisco WAAS? I've just started exploring this and wanted to see if anyone had success with this before I spend too much time. Thanks.
I'm currently having an issue getting NCM RTCD to work all the time. In previous jobs I had RTCD set to check 10 min after anyone logged on. I had no trust in my techs, now I trust them and no longer need to be big brother and just want to know if a command gets lost after a reboot. We are a Cisco shop and have RTCD setup…
I am using real time change detection with SNMP traps and I am getting all the right looking alerts but even when I make a change to the configuration I still get the message "no change detected, discarding config" I know that RTCD downloads the config when you first enter configuration mode, but it should be recognizing…
Hello - We have a weird issue here, well I think it is weird. It seems that when a configuration is modified on the Brocade switch stacks the alerts is sent out, but it states that the whole configuration was removed. Then a few minutes later we get another alter showing all the lines of the configuration have been added…
Hello all- I have RTCD working with Cisco and syslog. However I am new to the wonderful world of Brocade, but fulent in the great land of Cisco. I was wondering if anyone has the RTCD working with Brocade equipment? If so how did you get it working through syslog? Or did it have to be with SNMP? Thanks!
I've discovered a niggling little bug in the RTCD feature during testing, and was wondering if anyone else had run into this and if so, what resolution they found. Basically, it seems that if the logging source IP address is different than the NCM polling address, the config change will not be detected inside NCM. The…
Been playing quite a bit with Policy Compliance and remediation scripts and one thing I've noticed is that after the script is run on a node, RTCD is very slow at processing the nodes for updating. The last lines in my remediation script are "write mem", so I can see it triggering RTCD in the Trap Viewer on the server. I…
It looks like you're new here. Sign in or register to get started.