The most recent content from our members.
I am using the out-of-box notification Alert me when any hardware component goes into a warning or critical state as we want to begin monitoring the hardware. Here is the message details - Subject - ${SensorDisplayName} on ${NodeName} is ${SensorOrionStatusDescription} Message - The ${CategoryName}, ${SensorDisplayName} on…
So I'm wanting to compare a large chunk of config with a policy in Policy Manager (to a bunch of devices within NCM) which is roughly 30 lines long - the section for console access; line con/vty/tty on Cisco devices. This is of course possible by making ~30 rules, one for each line, but I'm pretty sure it would be easier…
Hi All, We've recently given our Orion systems a major overhaul. We took the oportunity at the time of licence renewals to increase NPM to an unlimited licence and add in IPAM SAM and NTM. We also installed them all onto a new hardware server as opposed to the virtual one it was previously on to give the system some umph!.…
Is it necessray to configure the node to send trap to configure the environmental alert using custom node pollar in advance alert in NPM 10.3????? Kindly guide me if any1 knows.Thanks in advance.
I'm new to SolarWinds and just setting up alerts for the first time. One of the alerts I configured was to check for low disk space: Trigger Condition (when all apply): Volume Type is equal to Fixed Disk Volume Percentage Used is greater than 95 Volume Percent Used is not equal to -2 Caption is not equal to Physical Memory…
I've been scouring for a way to do this. We're constantly getting diskUsgThreshExcd traps sent to my SNMP monitoring system. We have separate monitoring for this outside of Storage Manager so I would like to disable them. Here's where it's interesting. The Default OS Policy does not include the Rule for this Threshold…
Hi, Where do you go to setup email alerts in NPM. The following is an output taken from Solarwinds NPM admin guide :- " To configure an email/page action for a basic alert: 1. Click Send an E-Mail / Page, and then click OK." Not sure where I need to be in order to get this started. Any advice would be appreciated. Just…
Hi, From last 3 months , SW is working fine & we are getting all the configured alerts/events correctly But since yesterday we are not getting any alerts/events logged into SW event log as well as we are not receiving any e-mails. Today I checked in the Alert Manager to test the alerts manually. When I do the test manually…
how do I get an alert from a single node in the NPM? I get alerts of us who have, like someone who gets up email alerts, but a single node.
Hi - I have a basic alert setup for disk space monitoring. It sends out an alert every 15 minutes and I would like to change that frequency to every 120 minutes. I don't see an option to change this in the alert... I tried using advanced alerts, but it sends out alerts when the hard drive capacity remaining is 1%, not 1GB,…
It looks like you're new here. Sign in or register to get started.