The most recent content from our members.
Ok Everyone - Hope all is well. First off - I am NOT a SQL/SWQL guy. I am in need of some help. I want to create a table on one of my dashboards that list the UPSs that need a battery replacement, as well as the battery needed. This is just to speed things up when ordering replacements due to the variety we use. Here is my…
I've found a few things, mostly really old, on this subject. As far as I can tell, monitoring an HP server via WMI doesn't show the RAID controller battery status at all, just the disks. From old stuff I found, it would seem that monitoring via SNMP is the only supported way to do that. My questions are: is that still…
I have a Universal Device Poller (for Eaton) that get me the Battery run time in seconds before UPS turns off due to low battery. I would like to create a formula where I could use this UnDP to have display in a time value. somthing Like 1h 21min 34sec. Is that possible. The only thing I did for now is…
The goal: Create a report that will show APC UPS's with a battery date older than 3 years. Why: We would like to keep track of aging equipment and be able to see which UPS's should have their battery replaced before the battery replace indicator goes off. I am currently using Universal Device Polling to get the…
Can some one help me write a SQL scipt. I am trying to get a report together to show the last time our Batteries were tested on our UPS's. I would like to get a list of all UPS that are over 3 years since last replacement. I have located the MIB and have it loaded in the Custom Pollers and can see the information fromthe…
Does anyone here know how to get Orion to pull the Powerware MIB that shows the Battery install date or last time the batteries were tested? I would like to try and get Orion to get this information that have to buy another network tool.
Hi, I was wondering if it is possible to have my text highlight in Red if a Disk become anything other than online and as another example our Dell Battery state (below) is discharging so I would like to have that hightlighted in red too, possible?
Hey everyone, I have been monitoring our UPSes over the years both by watching the input voltage and the estimated remaining battery capacity. Last week we had one site where the utility power was all over the place and the UPS at site kept switching to battery. So, while the input voltage was above or around the theshold…
It looks like you're new here. Sign in or register to get started.