The most recent content from our members.
Eaton Powerware is one of the biggest UPS manufacturers, I think they are even bigger than APC if you look to the marketshare (do NOT quote me on this though). Could we please get native polling for these devices, like we get with the APC UPS:s? //M
Hello all, I haven't been working with Solarwinds for very long, only a few months. In that time I've managed to piece together this little dashboard that allows me to monitor reported battery capacity and reported runtime on APC and Eaton UPS within our environment. Here's a photo of the dashboard. What I'd like to…
Merlin Gerin/Eaton devices were acquired by APC and are basically the same as an APC device. Not 100%, but mostly. So I'd like to see them have the same UPS backup monitoring such as APC's have. Can we please get to that feature parity? I can see this being a more simple/general concept in line with
Template to monitor Eaton Powerware UPS via ConnectUPS Web/SNMP card. This was setup to handle a 3 phase unit, but can be used for single (110 & 208 volt) by disabling the monitors for the other phases (B and/or C). Currently there are no thresholds set.
I have a Universal Device Poller (for Eaton) that get me the Battery run time in seconds before UPS turns off due to low battery. I would like to create a formula where I could use this UnDP to have display in a time value. somthing Like 1h 21min 34sec. Is that possible. The only thing I did for now is…
Created for Eaton EPDU
Monitors battery capacity, runtime, ambient temp, input voltage, current and wattage as well as EMP sensors.
It looks like you're new here. Sign in or register to get started.