Current Percent Utilization of Each Interface - not providing correct information

Question

Hi Everyone,

I was wondering if anyone else has ran into this issue with specific type of box for Performance Technologies.

On the node details page we have a box that should show the utilization for each interface at a glance, this is not showing anything on most of the devices, as you see below.

Now En0 should show traffic on it for rx/tx

Most of the other interfaces will only have traffic for rx.

I have even tried to change the bandwidth on the interfaces, re-polled, re-discovered and then changed the bandwidth back to the original setting and sometimes this will work at others it does nothing.

That said I should not have to go through this just to see if anything is going to report (even if it is wrong).

Any helpful information, would be greatly appreciated.

jfaldmo · Answer

In case someone else googles this problem and is directed here.... The Interface Bandwidth is 1.0 Gbps if you divide your current traffic (664) by 1 Gbps ( (1,000,000,000) which is essentially 0%. Anything less than 10 Mbps will be 0%.