Netscreen SSG550 MultiLink Interface

Question

I have some Juniper/Netscreen SSG550s that have a 4 T1 bundled into a ml1 interface.  My multilink interface shows up just fine, but the serial interfaces show up as Warning status.  All 4 serial interfaces are bundled into ml1 and are status up.

I don't have any issues with Cisco routers with bundled interfaces just the Juniper firewalls.  I want to be able to see up/down status of the serial interfaces but why does it show up as Warning and how can I tell Orion the serial  interfaces are part of the multilink interface

Running Orion 6.5.1

ppeters · Answer

Thanks for the demo link, we have several 550's that we need this functionality.  Following the demo steps to create a new custom poller, I browsed the mib db for netscreen and the only oid I could find for interface status was table based (nsIfEntry 1.3.6.1.4.1.3224.9.1.1.5).  Selecting and testing against an element returned status data for all 8 ports.  However, when attempting to assign the poller to a particular node, we get the following error when attempting to expand the Juniper/Netscreen entry in the list:

Orion Universal Device Poller

Syntax error:  Missing operand after "I"operator.

Response option is the OK button.  Once responded to, subsequent attempts to expand the entry do not produce any response.  Any idea what the issue is?

FormerMember · Answer

We have a video about the UnDP that you might find useful:

www.solarwinds.com/.../index.html

WendyD · Answer

Kenny - I am not that familiar with custom pollers and how to create them.  I have read through the documenation and can't seem to grasp it.  The online help video refers to Custom MIB Pollers however, v9 uses Universal Device Pollers which is completely different on how it works.  I also found under the Orion NPM Universal Device Pollers downloads where you have a download out there for Juniper/Netscreen VPN Status (bytesIn, bytesOut, P1, P2, Gateway IP details).