I'm trying to restart a Palo Alto firewall process via NCM. The full command is "debug software restart process management-server" when I look at the results in NCM i see the following:
debug software restart process management-server
debug
debug software
debug software restart
debug software restart process
Unknown command: debug
It appears NCM is entering only part of the command per line? I haven't seen this issue with Cisco and Juniper devices. I'm able to execute "show system info" from NCM on the same Palo firewall without issue. The command works fine when manually entered from the CLI (no enable or other command required).
Thanks!
Matthew
