Our MikroTik backups have stopped working properly some of the time. NCM is seemingly recording commands typed 1 letter at a time and including them in the config. I don't know if this is a problem with NCM or a problem with MikroTik
Here is an example. NCM should login and run the command '/user export terse ; /radius export terse' but its echo'ing it back to NCM and recording these. And not exactly the same every time hence it see's this as a config diff
BEFORE | AFTER |
| / | / |
| | / |
| | ... |
| | /u |
| /u | /u |
| | ... |
| /us | /us |
| | /us ... |
| | /use |
| /use | /use |
| /user | /user |
| /user | /user |
| | /user |
| | /user ... |
| /user e | /user e |
| | /user e ... |
| | ... |
| | /user ex |
| /user ex | /user ex |
| /user exp | /user exp |
| | /user exp ... |
| | /user expo |
| /user expo | /user expo |
| /user expor | /user expor |
| | /user expor ... |
| /user export | /user export |
| /user export | /user export |
| | /user export |
| | /user export ... |
| | /user export t |
| /user export t | /user export t |
| | /user export te |
| /user export te | /user export te |
| /user export ter | /user export ter |
| | /user export ter ... |
| | /user export ters |
| /user export ters | /user export ters |
| /user export terse | /user export terse |
| /user export terse | /user export terse |
| | /user export terse |
| | /user export terse ... |
| | /user export terse ; |
| | /user export terse ; ... |
| /user export terse ; | /user export terse ; |
| /user export terse ; | /user export terse ; |
| | /user export terse ; / |
| /user export terse ; / | /user export terse ; / |
| /user export terse ; /r | /user export terse ; /r |
Nothing has changed on NCM. This seems to have happened after a MikroTik update but it doesn't 'always' happen with every single device on later firmware versions
Are there logs I can look at in NCM to perhaps determine exactly whats going on? And then importantly is there something I can fix/change in NCM to stop this from happening?
