With NTM eval, devices do not show up on map

I am trying to get an accurate map with the trial version of the Network Topology Mapper to see if I am going to purchase the full version. I have put in an IP range and SNMP credentials for mapping all the switches. They have been identified but are not showing up in the map. Do I have to have the full version for the devices to appear in the map?

Find more posts tagged with

network_topology_mapper

network_topology_mapping

ntm

Accepted answers

riviecc

Found that you can drag and drop from the panel on the left onto the map and has the proper linking and everything as needed. Thanks for the suggestions bkyle!

All comments

bkyle

Under Node Display Options, what do you have selected?

riviecc

Every option available is checked.

bkyle

What do you have checked under Discovered Nodes?

riviecc

I don't have any check boxes, this is all this section shows:

Discovered Nodes.PNG

riviecc

Found that you can drag and drop from the panel on the left onto the map and has the proper linking and everything as needed. Thanks for the suggestions bkyle!