Forum,
I have ran into some challenges while discovering switches in Network Sonar discovery.
I will use an example.
I am running a test discovery on a Cisco 4006 device.
During the import of the discovery, we have the ability in both the interfaces section as well as the ports section to select/deselect Trunk and access ports.
For some reason on the 4006 device, unless "Unknown" is selected in the Port Mode column, the import wizard does not show any interfaces to be imported.
Is there a proven method by which I can always import only the trunk ports and not the access ports on a specific discovery?
Thank You,
KMNRuser
