Universal Device Poller Paper Tray Empty

Question

I am trying to setup a UDP to identify a specific printer to display paper status.  I ran a MIB walk against the printer and found 2 mibs that are tripping me out a bit as they are listing as such:

I'm basically just looking to add some sort of alert, but I'm not sure if I need to add both of these MIB's or not to get it working properly as I added the second one down 1.3.6.1.2.1.43.16.5.1.2.1.2 with the following setup:

I hit next and test it against the printer and get the output I'm looking for:

The Output seen above showing Empty. Add Paper is displaying because I intentionally removed the paper from the printer; if I leave paper in I get no output which is what I want.  I push forward and attach the poller to the node, but when I go into the nodes details to monitor and see it populate with a status of Empty. No Paper I get nothing.  Not really sure what I'm missing here, but any ideas on a move forward is appreciated.

mmelton · Answer

Have you tried changing the data type to make it a true/false value? Then hopefully it will be seen as, if empty it is true. That might be one way to go about it

jpvenuto · Answer

Did you assign the poller to display on the Node Details page?

Thank you for taking the time out to reply...  Yes I do have it displaying on the Node Details page.  It just sits there even if I remove paper from the printer in an attempt to trigger with no luck.

mmelton · Answer

Did you assign the poller to display on the Node Details page?