Is 8.1 alert variables documentation correct?

chris.schear

Custom Node Poller Variables

The following are valid custom node poller variables.

Note: At least one of the CustomPollerStatus alerts from the table below must be included in the trigger condition of any and all Custom Node Poller alerts.

Custom Node Poller Variable

${Node.NodeID}

${Node.LastSync}

${Node.ObjectSubType}

${Node.IP_Address}

${Node.Caption}

${Node.DNS}

 

 

---------- 

 

 

Custom Interface Poller Variables

The following are valid custom interface poller variables.

Note: At least one of the CustomPollerStatus alerts from the table below must be included in the trigger condition of any and all Custom Interface Poller alerts.

Custom Interface Poller Variable

${Node.NodeID}

${Node.LastSync}

${Node.ObjectSubType}

${Node.IP_Address}

${Node.Caption}

${Node.DNS}

 Both "Custom Node" and "Custom Interface" variables are ${Node....} ???  Is this correct?  Typos?

MTorok

No sir, this is not a typo. If you take another look, you will see that the interface section lists specific interface variables further down the table. The repetition of the node variables is telling you that the node on which the interface exists is available to you through interface variables, also.