Fire Eye system load

simonhoo79

Hi,

I have a script given by the FireEye engineer to capture the unit system load, but not sure which part of it to be used.

I have created a test SAM Template to test the script, but fail to work.

So posting here to try my luck if able to get some help or a ready template.

Thanks.

error-script-14Apr.docx

mbussey

there may be  other tweaks that need to be made for it to run but a good place to start is in the output or returned values and the method in which they are formatted. For SAM to accept output Message and Statistic it needs to be labeled in the output.

This should help;

Creating a Linux/Unix Script Monitor

Code in question in your script:

then

    echo "High - ${sysload} > than 80"

else

    echo "Normal - ${sysload}"

Look into the link above on how to define output format. There's an example section output that's in red.

Also - Ensure the script runs locally on target device (assume since FE created it, it does)