Community
- Command Central
- MVP Program
- Monthly Mission
- Blogs
- Groups
- Events
- Media Vault
Products
- Observability
- Network Management
- Application Management
- IT Security
- IT Service Management
- System Management
- Database Management
Content Exchange
- SolarWinds Platform
- Server & Application Monitor
- Database Performance Analyzer
- Server Configuration Monitor
- Network Performance Monitor
- Network Configuration Manager
- SQL Sentry
- Web Help Desk
Free Tools & Trials
Store

Find all devices not containing a line in running config

mipe

Im new at NCM so i may be simple.

I would like to list all devices (Cisco Switches) that does contains a config line.

access-list 10 permit 10.10.10.10

I can't figure out a easy way to do it.

I have pushed out a config change to a LOT of devices over a few times. Now i want to confirm i did not forget any

Find more posts tagged with

Accepted answers

njoylif

you can do this one of several ways.

graphical output -> use the policy checker. pretty intuitive to use

text output -> you can set up a job to execute a command like
sh run | i <your criteria here>

this will give you a lot of "noise" in the output, but will give you the info you need.

All comments

njoylif

you can do this one of several ways.

graphical output -> use the policy checker. pretty intuitive to use

text output -> you can set up a job to execute a command like
sh run | i <your criteria here>

this will give you a lot of "noise" in the output, but will give you the info you need.

mipe

I knew about the text output, but the only way i could get it working was to send a snippet to alle devices. Then i had to check 60+ feedbacks one-by-one.

I had thought about the policy solution, but i just found out where to find it. I looked first everywhere in the web part with 0 luck.

Now i have created a Rule, a policy and a report.

And it works fine, from the server running the report in NCM Policy reporter.

On the web interface i can see the report but get this output when i run it

REPORT DETAIL

Did not search any device configs, no devices were selected.

What am i missing ?

mipe

I works now, is there some scheduled task that need to run before it works through the web interface ?