NCM Device Template Set Command on Disconnect

Question

Hi Folks,

We are facing the current Challenge on some Juniper devices that NCM is setting the following command when getting the config:

"set console page 0"

This is then stored on the Device and when an admin manually connects to the device the config runs through without any stopping point.

Is there a Possibility to run the following command upon disconnecting from the Device:

"set console page 22"

Thanks for advice!

Holger

HerrDoktor · Accepted Answer

it seems there is nothing to do on the disconnect, so we skipped the "set console page 0" and gathered the config by hitting "more"