Direct SNMP monitor Meraki Switch stack using NMP

gwarn70

Any one have a solution for this?

I am able to only see the ports associated with the first switch in the stack

Running 12.2 SP3

In the process of upgrading to 2019.4 (perhaps resolved there?)

Cannot find much in the way of others reporting this issue.

We have several stacks (mostly MS220s or MS120s)

mesverrum

Meraki SNMP support is famously terrible, they were very late to even begin to add it to their products and it is still super spotty so some things you would expect don't work, or if they do work it's being done in a way nobody else does it and that makes life hard for monitoring.  

Any time you have trouble with meraki stuff the best bet is to run SNMP walks against the device and first of all confirm if the data you are looking for even shows up, if it doesn't then you have to get into meraki about them fixing their data. Assuming you can find it in the walk you can open a ticket and send that walk in to support and ask that they pass it along to dev to see about getting it added to future releases.