Brocade Switches running vs. startup

hohwielerse

Dear all,

we have the problem that some of our Brocade devices include in the Running config their ssh certificate, that is written over multiple lines, using any character:

---- BEGIN SSH2 PUBLIC KEY ----
Comment: RomSecureShell DSA Public key
AAAAB3NzaC1kc3MAAACBAKZf6qtRHGHjPfOP3drwO1m28l4fpN5X5c8ArkeKhV3a
TzY404uwCsSvfYQUw/s24E+989MWZxLUO0Ib+nV+hWlK0nxI85bQPIvOjaWNtbgg
OfNdz4VyNcLxxzsiJqNhQpGQ3LW2zQ7fsP9pM5ALAs7MDOaSdNja58aUgEMY1ta5

....

---- END SSH2 PUBLIC KEY ----

Is there a way to get this out of config comparison? The certificate is missing in the startup-config, so the devices are marked with config mismatch...

Thank you,

Sebastian

Network_Guru

I have the same issue with Cisco routers with certificates which show up in the running config, but not in the startup config.

I've been searching for a few hours now on how to specify the comparison criteria used for the flashy pie charts on the default config summary page ?!?

• Last 10 config changes
• Overall Config changes snapshot
• Overall running vs startup config conflict

What am I missing?