Hello All,
We use NCM to backup a Cisco WLC 4402. Sometimes the report will show changes have been made when I have not made any. Often the report shows the below changes being made.
- memory monitor error enable
- memory monitor leak thresholds 102400 256000
Most recently I saw lines of code being removed such as
- network telnet enable
- network ap-priority disabled
- network rf-network 1 disabled.
I contacted Cisco and they stated the device should never change the config on its own and I am at a loss because when I go into the device the changes are not there. I am wondering if anyone else has had some weird results using NCM and the Cisco WLC?
