upgrade issue with ncm 5.1.1

after upgrading to ncm 5.1.1, the config change report now includes differences as minor as these:

BEFORE		AFTER
Today 17/04/2009 01:28:13		ADDS 4, DELETES 4, CHANGES 0


		<--- More --->

	<--- More --->

		<--- More --->

	<--- More --->

Find more posts tagged with

minor_changes

ncm_5.1.1

Accepted answers

All comments

chris.lapoint

If you are seeing "---More---" within your configurations, then most likely the commands referenced within the device template for the Reset command are either not correct or not complete. You can either modify the template or simply add <-- More --> to your comparison criteria.

deans701

Hi Chris,

Everything was working just fine with NCM 5.0.0.
The device templates have gone unchanged.

I did add and enable new comparison criteria as follows to alleviate the problem but unfortunately it didn't work.

RegEx Pattern:

^<--- More --->

Last nights job run revealed:

Today - 4/20/2009 12:07:51 PM		ADDS 12, DELETES 14, CHANGES 0

	<--- More --->

		<--- More --->

	<--- More --->

It only seems to be happening on PIX/ ASA profiles.

I have tried altering the "device command template" to both auto determine and the actual device type but it still gives the same results.

chris.lapoint

Ok, please open a support ticket on this issue and include a link to this thread. We'll need to figure out what changed between 5.0 and 5.1.1