Script to Clear Counters

jonchill

I've created a script to clear the counters on all our Cisco switches, the script is below, when I run it against a script

it runs fine without any errors but when I check an interface on the switch its still showing the counters with there existing levels.

I've tried a few things but get the same result

Can someone give me some help on where I'm going wrong with the script?

Thanks

Jon

 

clear counters ${CRLF} 

${CRLF}

fcaron

Found this:

Last clearing of "show interface" counters - The last time the clear counters command was issued since the last time the switch was rebooted. The clear counters command is used to reset interface statistics.

Note: Variables that can affect routing (for example, load and reliability) are not cleared when the counters are cleared.

in this doc: http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfd6.shtml

let me know if this helps