Hi,
We have setup the NTA 4.0.2 in our operation center. As we need to partition hundred of VLAN for different center operator, we create many user accounts with router limilation. However, if we uses the "Single group", rather than "Group of nodes", all the chart display wrong figure.
Since we have hundreds of interface, using pre-define group is easiler for managament.
We uses the trial version v4.0.1 on a clean platform, we get the same issue. Anyone have the same issue?
Thanks.
Fig 1: Without limitation
Fig 2: Using "Single group", which display wrong router data
Fig 3: Using "Group of nodes" which it displays correct data
