Zero Percent (what circuits are NOT being used...)

FormerMember

Hello all!  I have been tooling around in my report writer all morning trying to create a report using the details from custom properties to essentially show which circuits have less than 3% utilization for 7 days and then 30 days.  Since I'm the SW admin where I am, I apparently inherited the report guy.  So this was just handed to me to figure out.

Sounds simple, eh?  It's not.  I'm struggling.

I know all of my nodes are broken down in custom properies by MPLS-Router or Router, and my interfaces are all single T1 Serial or bundled Mu's.  I know what to select, but I don't know how to format the report.  Can anyone get me pointed in the right direction?

Thank you so much!

( I almost need to create the opposite of a 95% percentile report, I want the under used circuits to assist us in rightsizing, but I can't reverse engineer what that report has out of the box)

rfletcher

I attempted to do what you were asking but i have a lot of unused and back up interfaces being monitored  but did you try using selected fields "Node Name, Average Xmit+Recv Percent Utilization, Vendor, and interface name"  I used these to organize which interface on which nodes had an average utilization, then filtered that to where "field "Average Xmit+Recv Percent Utilization" is less than or equal to constant 3" from there all you should have to do is time frame to every 7 days or month.

On a side note after re-reading this I'm not sure if the data that is being pulled will be from current day or from a specified time period. Let me know if this helps.