Switch Port Mapper - empty?

Question

Hey folks,

I have used the engineers tool kit for a while, and today noticed something odd.

When I used the switchport mapper, it only shows the mac addresses of devices on the uplink/trunk ports. None of the mac addresses for the actual access ports are shown.  I have made sure the SNMP community I use is correct, as well as the gateway.

Anything obvious i am missing?

thanks.

Jason.Henson · Accepted Answer

dclick,

Did you define both the Switch/Hub and the Router/Server field before mapping the ports?  Typically, what I've found, is that missing one of these before the mapping will result in what you wrote.

Thanks,
Jason Henson
Loop1 Systems
http://www.loop1systems.com/