We use NPM to monitor a Microwave network which is mostly made up of Cambium (Motorola) PTP58500, PTP58600 and the newer PTP58650. The Interface Bandwidth which is shown on the Interface Details page of the Wireless Interface it shows the sum of the link capacity as both the TX and RX. It would be nice to have this reflect the actual TX and RX of the radios, rather than an aggregate value, to properly display Utilization charts.
Also, the PTP58650 does not report any throughput (bps) without using a Universal Poller. Not sure if it just hasn't been fully added to the system or not but this would also be necessary for Utilization Charts. I wasn't able to find a OID for this but the PTP58500 & 58600 both report this properly.
PTP58500 TX and TX Capacity:
RX Data Rate - 1.3.6.1.4.1.17713.5.20.1
TX Data Rate - 1.3.6.1.4.1.17713.5.20.2
PTP58600 TX and TX Capacity:
RX Data Rate - 1.3.6.1.4.1.17713.6.20.1
TX Data Rate - 1.3.6.1.4.1.17713.6.20.2
PTP58650 TX and TX Capacity:
RX Data Rate - 1.3.6.1.4.1.17713.7.20.1
TX Data Rate - 1.3.6.1.4.1.17713.7.20.2
Thanks,
Chase
