NCM Firmware Template for Cisco Catalyst 9000 install remove inactive

richard.dahl

I'm trying to figure out how to cleanup old files and packages after the catalyst 9000 install.  The installation runs great but trying to get the following command to run post install.

install remove inactive

y (answering yes to file to be deleted)

Thanks for any assistance!

sum_giais

Hi there @richard.dahl ,

You'd need to go into your NCM settings and edit the Firmware Upgrade Template you're using, by going to Settings -> All Settings -> NCM Settings -> Firmware Upgrade Templates.

From there, find the appropriate Firmware Upgrade Template and edit it.

NOTE: I've never used the "Verify Upgrade command" so your mileage may vary - looking under Upgrade Options, it appears to run after the reboot.

Inside the "Verify Upgrade command" you could put "install remove inactive${CRLF}y" like so: