Hi, we are using NCM to send out config changes by E-Mail. It would be great to not have passwords, secrets, hashes etc. visible within the messages. This would significantly improve security & compliance. Thanks, Ethan
Unable to modify Meraki switch configurations and to fetch periodical configuration backups through NCM module as SSH is not enabled on Meraki devices. We want to provide a few limited modifications access to some local IT users for modifying minor changes on Meraki switches with the help of the NCM module in…
Good afternoon, More information is needed about regular expressions that help us replace certain values contained in a baseline for NCM communications equipment. Example: * Keep the Hostname command but RO-LAB-01 replace it with the regular expressions or omit the name but don't ignore the command line. *This would help…
Hi I know some people are 100% sure that there’s no replacement for SNMP. Cisco and Juniper are on the same page ... I sure like SW to support minimum the ietf version. https://tools.ietf.org/html/rfc6241 YANG, NETCONF, RESTCONF Demos. Which Cisco devices are supported? (Part 1) - YouTube
New federal policy is mandating a SINGLE management and control of network assets. SolarWinds ORION has been a preferred solution, however with the NETCONF capability is a critical gap. Juniper has penetrated DOD and specifically US Air Force networks to nearly 50% success. As these networks are cutting over, we are…
Currently, when looking at the configuration for a device, it can refresh at any time. This means if you are looking at the configuration file for an error and it is a large file, it could refresh and the view automatically goes back to the start of the configuration file. Can the refresh be turned off so that it doesn't…
For security, we want to be able to change the SSH port that can be seen in "node details" from port 22 to port 1337 or any other port we would like to use. Here is what we tried: - We saw that it cannot be done from the SolarWinds.SSH.BusinessLayer.dll.config file - We saw that it cannot be done from the NCM…
I have hundreds of Juniper EX switches. If I want to upgrade all of my, say EX2300s, or perhaps even 10 of them, I shouldn't have to create 10 individual jobs in the firmware upgrade section of NCM. As long as the firmware upgrade template has the ${Subfolder} Macro in the install command, I should be able to create a…
Can we please get more than 7 days as an option for Last config back up date! Our switches do not change much where we would need to back them up weekly - that is a waste of space. If we could have the option to set this to more than 7 days - the graph on the main summary page might be useful Recommend 30, 60, 90 days
abbility to run external script that would check compliance.
It looks like you're new here. Sign in or register to get started.