Get the latest news about SolarWinds NetFlow Traffic Analyzer (NTA)
Since we send the NetFlow streams to 2 different systems I wondered if Orion can handle streams sent to it from a replicator device? For instance we also have Arbor that can replicate the data and forward it on. We are trying this without any luck. Basically we want to send 1 stream and have Arbor forward that to us as…
I am looking to see if it possible to create a report that would show the NetFlow details for the past 24 hours ONLY for the peak traffic times. I am reporting on traffic on an interface for the past 24 hours and it shows peaks throughout the day. Management would like to include on that report the Source, Destination and…
If a company already has NTA installed, how can I find out where the NTA flow storage DB is located? From the server hosting NTA can you give me direction where to look? thanks!
Our WAN is made up primarily of 2911 and 2901 routers. We have some 2800s that are being replaced. On the whole we have MPLS circuits at 1.5 or bonded in a Multilink to 3.0. We do have some larger circuits. We have a very simple NTA configuration on the routers. On the serial interface we have this: ip flow ingress ip flow…
Dear community, existing situation: company with two separated sites - one office and one datacenter site connected via WAN infrastructure NPM application installation together with separate database server on office site. current NPM deployment monitors office and datacenter equipment (so polling from NPM main poller…
Hi, I don't see any F5 sFlow data on the NTA. I have checked my config is fine. The SNMP polling works fine and I can see the F5 devices in the NPM. I find below that the sFLOW is not supported by NTA. https://thwack.solarwinds.com/thread/53066 Any help on this please? Thanks, Vidhya
Hello, We're installing Cisco 4331 series routers at a couple of our remote sites. Each Router has 8 T1s in a Multilink. In NPM the available bandwidth shows 12.288Mbps. When I do stress testing NPM shows utilization is 12.288Mbps. When I check Netflow Traffic Analyzer during the stress test it shows utilization of…
I am receiving flows from my netflow source interfaces (time stamps are current and updating), but the Traffic In and Traffic Out columns in the NetFlow Sources resource always show zero. Any ideas on the cause?
Hello everybody. I have a litle pproblem with NTA. Easterday it stoped receive statistics form devices about applied service-policies on interfaces (CBQoS). This issue belong for entire device. There is no situations, where part of interfaces are monitored and part aren't. What can i do before open the ticket?
Hi everyone, I have a Cisco 1921 device registerend in NPM and as well in NTA. Interface speed is 100 Mbps, Line speed is 30 Mpbs. NPM stats on the WAN interface is showing well as you can see. On the other hand, the Netflow stats are up to 300 Mpbs. This is not real. Why isn't it 30 Mbps as in the graph above ? Kind…
It looks like you're new here. Sign in or register to get started.
