Comments
-
ok i will arrange that thanks for your help
-
i can add the command to vlan 1 but not the external, however i cant see any flows on the server
-
I seem to be getting flows after readding your template of commands so thank you once again, but the last router will let me enter all commands but " ip flow monitor MONITOR-1 input " on the external interface, it does not appear to be there, my ios is12.4(15)
-
Hey one site is sending lots of flows which is great , However the other site seems to only be sending snmp traffic shouldnt i see internet, email traffic, etc like the other one?
-
Hi have just done this but dont seem to be collecting any flows, does the source interface need to be the outside interface or Vlan1?
-
i have the traditional netflow configuration on the router
-
Cisco 881 router ios 15.1(4), we are using a site-to-site vpn, do i need to add any other commands and will this cause disruption for the site if i enter these commands now?
-
Hi, I am using the commands mentioned for the standard setup of netflow, i am unfamiliar with the commands you have provided, do site-to-site vpns have a different netflow setup than other routers?
-
having disconnected all attached devices one by one to the core switch i have discoverd a server with 2 teamed network cards that when disconnecting them both at once the errors stop on the router interface. i will move this server onto a single interface and see if that stops the errors for good
-
would devices that require their ports to be set to the right speed and duplex, if incorrect cause this problem?
-
I do have NTA but i am new to solarwinds, what should i be looking for?
-
the router is a cisco 2921 connected to a cisco 2960 switch then that connected to 5 HP Procurve switches we have this kind of setup in all our offices and none others are having any issues
-
also all the input errors on the router are overruns what could be causing this?
-
started to disconnect all devices at the end of the day when everyone had gone home and the errors have now stopped, maybe someone on the network is causing these errors from their pc...virus perhaps?
-
I have changed the router port, uplink cable and port on the switch but still receive errors on the router interface, should I go through a process of elimination by disconnecting all devices one by one until the errors stop?
-
hi im only seeing errors on the router port. i have changed the switch port for the uplink and the network cable, the switch isnt receiving any errors, both have the same speed and duplex, it is fluctuating but is around the 2.5 to 3 week mark
-
Hi Guys I have changed the uplink cable and can see no obvious issues in the logs, solarwinds reports that after a gradual build up of errors after about the 3rd week the interface receives a huge amout of errors in one go like 4 million... the network is then unable to contact the router until you reboot the switch, then…
-
Cheers dude, I am using page gate for text alerts now, can schedule 3 per day