jclukey

Chrystal: Thank-you very much for your help with my issue. I was able to figure it out. In order for me to meet the requirements that I outlined above; that the escalation group only receive alarm cleared messages if they rec'd an alarm raised after xx minutes was to create a totally separate alert (and set the escalation…

Chrystal: OK. I have the alert escalation down on the trigger. Now I have a question with regards to the reset action. My question is this. How can I control the reset messages? What I mean is, I only want the recipient that received an alert escalation message to receive an reset message only IF they received the alert…

Chrystal: Ah-hah. I think the ol' lightbulb just went on. So, on the secondary alert action, I would set the alert escalation to the effect that if this alert is still raised say after 30 minutes to execute this action but if the alert has been cleared before the escalation timeout than it will not get executed? Is my…

pyro13g: Again thank-you very much for the information. It helped quite a bit. And, as I just posted with regards to power; Is there a way, in the alert, to have the the alert formatted very much like you have it shown above for Fan Status? Any help would be greatly appreciated. As always, TIA for any help.

pyro13g: Forgot to mention one other thing. A lot of our switches 4507s, 6509s, 6513s, etc. have larger power supplies such as 6000W power supplies. Each power supply has two 220V plugs. Is there a way to monitor and/or alert when there is an issue with one of the plugs? And if so what OID/Alert variable would you use? I…

pyro13g: I apoligize for not responding sooner, but I had a few emergencies that had to be taken care of. Thank-you very much for responding to my post. I just have one more question with regards to the power alerting. I would like the output in the email/alert to look very similar to the output that you posted above. What…

Chrystal: I apologize for the delay in replying as I got pulled off on something else. I still do not understand where you add a different recipient or list of recipients on the escalation tab. Or do I have to make a copy of the alert and in that one I have the escalation set? Please advise as it appears I am a little…

First of all I'd like to apologize for not responding sooner. I'd also like to thank-you for responding but as far as I can tell there isn't a 1.3.6.1.4.1.9.9.388 branch. So...

Chrystal: Thank-you very much for replying to my request for assistance. Yes, I did see this; however, I did not see where you could enter recipients for this escalation notice. Example. You define your alert as you normally would. If a particular condition is met, you send out a message of some sort to a person or group.…

Chrystal: Thank-you for replying to this question as well. I guess I was wondering if there is anyway to see this information from the web front-end w/o having to go into the database to query this table or that. Is there a way? Or is the only way to do it via your suggestion/answer above? Again, thanx for the help.

Bret: Thank-you very much for replying. But that is just it. Under the trigger condition, I have chosen Custom Node Poller and the condition that I test for is Numeric Status is not equal to 1 (Not Normal). The problem that I have is in the message of the alert. What variable do I use to list out the Power supply that is…

To all: I noticed that no one has replied to my question as of yet. Was it because I was not clear enough? If so, please advise what additional information you would need or like and I'll post. As I am still looking for an answer to this question. TIA.

Cisco ASR1001-X SysObjectID: 1.3.6.1.4.1.9.1.1861

To all: I am still looking for an answer to this question. Any help would be greatly appreciated. TIA.